Lodge HighwayLogo Design Contest

Hi Clone5,

Thanks for feedback, update proposal #91, let me know your thoughts.

Regards,
Jefry

Can you increase the size of the pistons and cross them
If possible simplify the detail

The pistons to bring to foreground
Add horizon
Add "837"

Hi Clone5,

Update proposal #65 and #66, let me know your thoughts.

Regards,
Jefry

Rotate the small Square and Compasses logos to be on the horizontal.

S&C's stands for Square and Compasses, which are the masonic logo. MY mistake. Please remove "S&C's" and shift the UGL text back inside the circle

Hi Clone5,

Thanks for feedback, update proposal
- #62 revision base on entry #46
- #60 and #61 revision base on entry #31
Let me know your thoughts.

Regards,
Jefry

We have a few other requests on this
1. pistons to come back inside, behind square and compasses but same orientation as the square @ 90degs. Conrods and pistons visible
2. remove sprockets
3. add 837 to the Lodge Highway text curve
4. Lodge Highway text curve font to change to something clean like Arial without the serifs

Move and duplicate square and compasses to replace sprockets "837" to come up to replace S&Cs
UGL NSW & ACT to follow lower curve

That's looking good. Can you squeeze the number in around the top text? May have to remove the sprockets

Hi clone5,

Update proposal #45 #46 and #47, let me know your thoughts.

Regards,
Jefry

I don't think the pistons and rods look right.
Can you also remove them
Move 837 somewhere else and put "UGL NSW & ACT" where it was
What if the pistons were bigger but behind the whole circle and crossed over?

Hi Clone5,

Thanks for feedback, update proposal #40, let me know your thoughts.

Regards,
Jefry

Can you bring the pistons forward
Add a horizon
Remove one of the road curves
Play around with the font

Hi Clone5,

Thanks for feedback, update proposal #29 #30 and #31, let me know your thoughts.

Regards,
Jefry

If the square and compasses were much larger and behind everything, there could be more room inside where the road is.
Words curved into a circle, White background and using the blue from the requirements

I like what you're doing with the road

If the square and compasses was not the focal point of the design, what should take its place?

Hi Jefry
We need to stay away from skulls etc. This is not an outlaw motorcycle club.
The pistons were a nice touch and one of our BMW riders liked that they were in a 180deg boxer configuration
Play around with the sizes of each component.
Lose the black background

Greetings...

I submit a new designs proposal. I am open for feedback, don't hesitate to let me know. Your feedback is very useful

Regards
Jefry