PumpCurv Inc.Logo Design Contest

That great!

#285 #286

Can you increase the space a very small amount between the u and m, and u and r, just a very small amount?

Almost

Perfect

#283 #284

Can you lower the dot triangle on the i so the corner touches the vertical stroke.

Please see revised entries.

Thanks!

In a different version can you use Small Caps for the INC. only, drop the dot at the end of the inc and use a small triangle for the dot on the i oriented the same way as in the P.

Can you make INC. slightly bolder and drop the dot.

Please see #277 #278

Sorry, for my poor triangle explanation. The triangle cut out points should be rotated clockwise.

Hi,
Thanks for feedback. Please see revised entries and let me know if you want any changes.

Regards,
digiartz

Please disregard the comment suggesting Delta P triangle, but continue orientating the triangle with the 90 degree point at the top right.

Can you remove the triangle cutout on the top of the P and incorporate this triangle, inside the P (where the current cutout or hollow is), and rotate this triangle to represent a Delta P Pin triangle, as seen on pump curves. So a triangle with the 90 degree in the top right.