Heat BlockLogo Design Contest

Hi, I will send you high resolution file in a few minutes.
Also pleas note that you have eps file which can be scaled up without losing quality (but it requires special software) ...but basically it will be useful for printshop if you need to print something bigger.
Best regards
Sebastian

Hi, I need the logo in high resolution. Even the biggest one here is smaller than 1 mb. Can you send one in high resolution as this should have been done. Thank you very much.

Thanks so much!! Now i will just look carefully and pick one of yours. Thank you for your patient.

Here is new version #60

I ment for this one. Exelent! Very good. Now make the fading adjustment on the belt of the batch. Then I guess we are finished. :)

Exelent! very good! Now make the same fading adjustment on the belt of the batch

Hi, here are new entries for you #57 #58 #59

- Add TM (trade mark). Do the TM at the top right line. Make it a bit shorter to add TM in same hight as the line. That way the end of the letter M will be aligned at the right with the line at the bottom right.
- Make the black cross line fade like the grey at 56, and also the lines black, but faded like 56.

Hi, Here is mix of entry #52 with letters from #54

Okey, i go back to this one. Love the fading of the lines. Can you do this one with the letters from 54.

Thank you, new versions are: ##54 ##55

Good! We are closing in. Can you try and make all grey in black? Both on lines and batch. And make the lines same width as the letters? And the Batch about 10% bigger..

Thank you,
I've just submitted revisions for you.

There is something about the harmony between the logo/ stripes and the batch. Could you try one with the lines in grey and thickness as the line around the batch? But keep the letters black.
Then you have many comments from me to work with. Dont hesitate to ask if you need.

And adjust the space between L and O so it follows the space of the next letter like the E and A. Make same distance from the batch to the letters as between the letters.

And a little thinner letters, like you used to have. They are too bold.

Thanks,
Just litlebit smaller letters. Adjust letters and lines so they dont interrupt the centre batch.

Yes, of course, I've just uploaded version with square letters for you

Can you make the letters more "squere"? Like the one logo at fourth place?

Thank you,
Please let me know if you need any changes.
Best regards
Sebastian

Very nice!